What is the loft and lie of a 1998 Nicklaus Air Bear Pro Carbon Pitch Wedge?
Scott, Covina, California, USA
Scott
Sorry to not have 100% accurate information. But, most of the airBear irons from that timeframe had 63.5 degrees lie and 47 degrees loft.
Regards,
Gary
January 1st, 2012. Read more articles on Specifications.
I am re-shafting a Ping G2 pitching wedge. The final length is 35.5″. What is the tipping requirements?
Steve, Fayetteville, Arkansas, USA
Steve,
The club requires a taper tip shaft in the shortest length available for the flex -usually @37″. It does not get tipped; butt cut to length.
Regards,
Jeff
December 13th, 2011. Read more articles on Reshaft.
Hi. Can a PX pull out from Callaway X22 iron fit into a Titleist ZM iron? Thanks!
Denis, Singapore
Denis,
The X22 is .370″ parallel. The ZM is .355″ taper. The shaft will not fit. If it is an X22 Tour, then the shaft is also .355″ and it will fit.
Regards,
Jeff
December 13th, 2011. Read more articles on Reshaft.
I’m an 18 handicap. Do you think I would benefit from same length golf clubs like those made from 1 iron clubs? It would seem that with all heads the same weight and lie, all clubs same length and ball in same position, that my swing would be more consistent.
Brian, Greenwell Springs, Louisiana, USA
Brian,
I am not a fan of 1-length clubs. Typically unless they are made 100% correctly, long irons are too light and short irons too heavy. Unless lofts are adjusted correctly, long irons tend to go shorter and short irons longer. The finesse shots around the green are more difficult as well with longer short irons. No major golf company is pursuing a 1-length set at this time and Tommy Armour Golf abandoned it over 15 years ago - thus there must be good reasons why each club is a different length.
Regards,
Jeff
December 1st, 2011. Read more articles on Fitting.
I’d like to reshaft a Cameron Circa 62 #2 putter. Do you know what type shaft I’m looking for and where to find it? Also, is there a possibility of find this shaft in black?
David, Acworth, Georgia, USA
David
It is a .370 tip putter shaft. I do not think it is available in black. Try www.hireko.com or www.golfworks.com.
Regards,
Jeff
November 30th, 2011. Read more articles on Reshaft and Products.
News from GolfBallTest.org
News from Equip2Golf.com
